Ultra Tile Fix ProLevel Fibre Levelling Compound 20kg

Description

Ultra Tile Fix ProLevel Fibre is a single part, high strength, rapid drying and curing concrete floor leveller. The product’s formulation incorporates a blend of specially graded fillers, cements, polymers and fibres. It is mixed with clean cold water to give a free flowing product that can be applied from 3-75mm in one application.

Ultra Tile Fix ProLevel Fibre is supplied in 20kg bags.

The specifically formulated fibre technology aids application and strength resulting in a strong, sound and even base ready to commence the tiling process after only 8 hours. Ultra Tile Fix ProLevel Fibre has a fast set time (in good ambient conditions) and enables light foot traffic in 3 hours.

Ultra Tile Fix ProLevel Fibre is suitable for a wide range of substrates – concrete subfloors, tamped or pan floated concrete, sand/cement screeds, existing smoothing underlayments, terrazzo/granolithic ceramic tiles, anhydrite/calcium sulphate/gypsum based screeds, plywood/tile backer board, warm water underfloor heating and radiant electrical underfloor heating systems.

Application:
Mixing ratios of powder and water should be controlled to ensure a free flowing material suitable for 3-75mm application. Do not use excess water as this will affect the product performance and finish. For trowel/hand application mix in a clean bucket using clean cold water, as warm water will greatly reduce the product’s working time and may result in shrinkage. Pour 3.4 litres of water into an oversized bucket (20+ litres), and then gradually add the Ultra Tile Fix ProLevel Fibre powder whilst mixing continually with an electric drill with power whisk. When all powder is added mix for a further 2 minutes, keeping the whisk below the surface (to minimise air entrapment) until a lump free creamy material is attained.

Once mixed, Ultra Tile Fix ProLevel Fibre can be applied by pouring onto the floor and spreading with a smooth edge steel trowel. Plan to begin at the furthest point working back towards the point of entry to avoid walking through wet product. Maintain a wet edge to ensure adjacent mixes blend in correctly. For large areas or deep sections it may be beneficial to batten off areas into sections. Keep free from floor traffic and other trades whilst curing.

Technical Data
Classification: CT-C35-F6
Depth: 3-75mm
Working time at 20°C: *20-30 Minutes
Walk on hardness time at 20°C: *3 Hours (3mm application)
Commence the tiling process: *8 Hours (3mm application) *24 Hours (5-15mm application) *48 Hours (15-30mm application) *72 Hours (30-50mm application) For depths above 50mm leave 7 days before commencing the tiling process. (*Depending on substrate porosity, nature of flooring and notes in Curing & Drying above.)
Compressive Strength (N/mm²): 28 Days: 35.0 (to BS EN 13892-2) Flexural Strength (N/mm²): 28 Day: 6 (to BS EN 13892-2)

Coverage:

Product Datasheet

Click here to view this product on the Manufacturers website.